DVTELL Ioimage trk-101 Manual de instalación descargar pdf (Pagina 16)

Installing and Connecting the Unit

To power to the unit using a power outlet:

1. Connect the AC adaptor output to the terminal block on the power connection panel of the

unit.

2. Connect the AC adaptor to the power outlet.

Warning:

To prevent bodily injury or damage to the unit, use only properly rated and approved power

supplies and/or AC adaptors.

Warning:

Make sure that the power supply matches the required specifications. Electrical safety should

always be observed.

3.2.3 Connecting the Unit to the Network

By default the unit is shipped with the factory default IP address 192.168.123.10.

Caution:

Before connecting the unit to the network, set the unit IP address according to your specific

network requirements to avoid address conflicts. Refer to the instructions in this section on how

to change the unit’s IP addresses.

If your network uses firewalls, you must configure them to support communication among the units and

computers running the Internet browser used to connect to the unit’s web interface.

Note:

Refer to the HTML Edition Units User’s Guide for setting the unit IP address and required

firewall settings.

To connect a unit to the network:

1. Connect a PC/laptop directly to the unit using a network cable connected to the Ethernet port

located on the front panel of the unit (see Figure 3: trk-101 Power Connection Panel).

2. Change the IP address according to your specific requirements. (See following section.)

3. Disconnect the unit from your PC/laptop.

4. Connect the unit to the system network as follows:

a. Connect the network cable to the Ethernet port located on the front panel of the unit. (See

Figure 3: trk-101 Power Connection Panel)

b. Connect the other network cable end to the network switch/hub.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Sin comentarios

DVTELL Ioimage trk-101 Manual de instalación Pagina 16