DVTELL Ioimage trk-101 Manual de instalación descargar pdf (Pagina 11)

Introduction

Item

Description

Alarm Input

Single alarm input connection (a set of two wires) from an external device — for

example, a fire sensor, PIR (passive infrared) sensor, fence sensor, etc. — with a

dry contact output to the terminal block.

Relay Output

Dry output contact signal to a single external device (such as an electrical door

lock) to the terminal block. The terminal is for Normally Open configuration.

Reset Button

For setting the unit factory defaults, setting Technician mode, or a hard reset of

the unit.

LED

The LED indicates several status conditions:

 Off: The unit is resetting.

 Flashing green (300ms intervals): The firmware is booting.

 Flashing green (one second intervals): The firmware has booted

successfully, the encoder is connected to the network, and unit is

operating normally.

 Steady red: Failure in the first phase of the boot. Requires resetting the

unit.

 Flashing red: Failure in the second phase of the boot. Requires resetting

the unit.

 Steady yellow: Reset button was pressed for 5-15 seconds and entered

Technician mode. Requires resetting the unit.

 Flashing yellow (500ms intervals): The unit is in Factory Default mode. To

enter this mode, press the Reset button for 15-30 seconds. The LED

changes from steady state to flashing after five seconds. The unit’s

firmware returns to the factory defaults. When finished, the LED displays

flashing green.

Note: If the LED is pressed for more than 30 seconds, it will flash red, indicating

an error. In this case, disconnect the unit and reboot.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Sin comentarios

DVTELL Ioimage trk-101 Manual de instalación Pagina 11