DVTELL Ioimage trk-101 Manual de instalación descargar pdf (Pagina 31)

Appendix

A.2. Connecting Leads to a Spring Clamp Terminal Block

The unit is delivered with two terminal block connectors. The connectors enable you to connect wires for

either the Relay Output or Alarm Input and then connect them to the unit.

Figure 14: Spring Clamp Terminal Block

To connect a wire to the spring clamp terminal block:

1. Strip the insulation form the end of each wire that is to be connected to the terminal block.

Approximately 1 cm (2.54”) of wire should be exposed.

2. With a small screwdriver, press in and hold the orange spring clamp button next to the female

outlet where the wire will be inserted.

3. Insert the stripped end of the wire into the female outlet.

4. Release the orange spring clamp button.

Figure 15: Connecting a Wire to a Terminal Block

1 2 ... 26 27 28 29 30 31 32 33 34 35

Sin comentarios

DVTELL Ioimage trk-101 Manual de instalación Pagina 31